V847 True Bypass Mod


In Stock

By buying this product you can collect up to 5 loyalty points. Your cart will total 5 loyalty points that can be converted into a voucher of $1.00.


Add to wishlist


Choose your modifications from the drop-down menus to be installed in your pedal.

This mod is compatible with the Q control, Sweep Switch, Output Buffer, and Volume Swell mods.

Modification Descriptions:

True Bypass - Gets rid of that bad tone sucking bypass. A quality 3pdt is used to give it true bypass so you can maintain your tone.

Add LED - Add a 5mm LED to your pedal to tell when it's on or off. No more guessing or trying to figure out what's going on and then realizing your wah has been on the whole time! Requires drilling a hole.

DC Jack - Add a DC jack so you aren't restricted to only using a battery. Reverse polarity protections is also installed along with any power filtering if needed. Requires drilling a hole.

To send your pedal in for modification, print and fill out this Modification Form and send it in along with your pedal. All the information you need will be on the form.

Limited 5 year warranty



forgot to add

I also purchased the led, it would be nice if the instructions would mention where it is best to place it, as I placed it on the side where it is less visible from above


Good mod reasonably easy to perform

This mod is not difficult and in general well explained (only points: the instructions should say that the switch is symmetric and can be mounted in 2 equivalent orientations, and that the rubber feet might need to be trimmed if the switch shaft is not long enough).
I am happy I did this mod.

Write your review!

Write a review

V847 True Bypass Mod

V847 True Bypass Mod

Customers who bought this product also bought: